Installation Instructions for Two Handle Desk Mount Bathroom Tub Faucet Chrome finished tap mixer Two Handle Desk Mount Bathroom Faucet Chrome finished tap mixer This elegant waterfall style bathroom tub faucet comes in chrome finish and it perfectly complements any modern bathroom. It is deck mount, with two handles. The ceramic valve guarantees best performance and a long lasting life time. It is easy to install, it comes complete with accessories and installation instructions. Features: Suitable : Place Sink Installation Type : Centerset Valve Type : Ceramic Valve Finish : Chrome Faucet Total Height: 2.2 inches (5.5 cm) Spout Height : 1.5 inches (3.5 cm) Spout Length : 6.3 inches (16 cm) Spout Width : 7.7 inches (19.5 cm Flow Rate : 1.0 GPM Specifications : BathSelect® Manufacturer Warranty Information

For the following Installation Instructions for your new Widespread Faucet, it is assumed that any old fixtures have been removed and any repairs or modifications to the water supply have been completed.

Unpack and inspect the product for any shipping damages. If you find damages. If you find damages, do not install it. Contact Customer Service at 1-800-856-(Bath)2284. If you need assistance or have questions while installing your Widespread Faucet, contact Customer Service.

INSTALLATION

Install the rough-in valve body behind the finished wall. Attach the valve body to wood blocking between two wall studs with wood screws. Be sure that the rough-in valve is completely level, and connect to the main water supply.

1. When the wall around the rough-in valve is finished, install your faucet trim.
2. If your faucet spout is not assembled, assemble by connecting the threaded outlet to the faucet body. If your spout is already assembled move on to the next step.
3. If your faucet features a decorative faceplate, secure the faceplate to the wall with silicone sealant before installing your handle and spout trim pieces. Make sure that the faceplate is properly aligned over the rough-in valve and perfectly straight. If your faucet does not feature a faceplate move on to the next step.
4. If the decorative spout escutcheon is not attached, place the escutcheon on the body of the spout and install the spout over the spout shank. Screw the spout into place and press the escutcheon firmly against the finished wall.
5. Tighten any set screws in the spout with the Allen wrench.
6. Install the handle(s) and any necessary hardware and tighten the set screws with your Allen wrench. If rubber O-rings or sealing gaskets are included, Place between the handle body and wall to create a watertight seal.
7. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight (no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the water to flow through the spout for approximately 60 seconds. Allow the sealant to cure for 24 hours before use.