Installation Instructions

Shower

1. Use a hexagon wrench to lose the lock screws then separate the showerhead assembly and bracket.

2. Dig 4 Ø10 holes on the ceiling according to the dimension of the screws.


3. Use a hammer to thwack the 4 screws into 4 holes.

4. Install the bracket on the expansion screws then use copper sleeve wrench to lock 4 screws.

5. Make sure all the water inlet pipe connected well without leaking before insert the power plug into the socket.


6. Fix the shower assembly on the bracket by turn the locking bolt.


Mixer

First, carve a rectangular slot in the wall that 1000mm high from the ground and two inlet water pipeline (the overall height shall not be greater than 1670mm).

Put the concealed box into the slot on the wall and fixed with the screws (no slipping, no loosening).

Link the hot and cold water pipes, then tighten the screws (Attention: Filter washer must be installed to avoid dirt clogging), finally paste up the tiles as the picture shows.

Link the hot and cold water pipes; accurately (please clean up the foreign body of connecting pipes installation, and hang up the preassembled panel components following the picture shows. (A must to all click into the B slot).

NOTES

1. Reasonable use of this product by technical parameters.
2. The product temperature control valve is an automatic thermostatic valve, will not be affected by the temperature change under normal using any of the following circumstances that may affect the use.
3. Low water pressure.
4. Hot water inlet temperature is lower than 38 degrees.
5. Cold aster temperature is too low.
6. Used with the gas water heater.

Special note: If the cold water pipe suddenly anhydrous, the thermostatic valve will automatically switch to stop the water, avoid the hot to bodily harm.

For a more rational use of this product. Here recommended the storage-type electric water heater. Maintenance considerations: