Keep the surface clean, regular cleaning.

Using water clean it, using a cotton cloth to wipe dry.

1. According to the dimensions and shape of the mounting bracket, determine the bracket location to be installed in the ceiling.

2. According to the 8 mounting holes on the mounting bracket, use Electric drill to make the mounting holes.

3. Using the two hexagonal nuts adjust the distance between the mounting bracket and the ceiling, and keep the mounting bracket on level.

Use explosion screw to fix mounting bracket on ceiling, pay attention to the explosion screw, it can adjust the height, and use level tool to adjust the mounting bracket to reach level.

4. Connecting Circuits

5. According to the chart shows: Raise the showerhead, Aim at the hole of the bolt, plug the bolt.

Use a phillips screwdriver screw out the upper cover 4 screws, open the plastic waterproof boxes.

Note: The same color line docking, brown line for line, blue line is zero line. Use a phillips screwdriver screw out the screws in plastic waterproof box wiring position, then put the fork terminal line connected, then fix it with a phillips screwdriver.

According to the circuit diagram as shown in step 5, then connect plastic waterproof case, please note that the same color of the wire when connecting circuit to docking.

6. Connecting water hoses and Tee joints and then connect the water hoses to the water inlet pipe connector.

7. Connecting 4 pcs water hose to 2 Tee joints and G1/2 joints in the middle and then put another side of the shower hoses through the showerhead side holes.

8. Installing the shower body by plugging the bolts. (As the above picture )

Shower Holder Installation

1. Open the closed cover of the shower holder and take out the screws.

2. Drill two holes size 6mm on the wall according to the hole position of the shower holder. Use a hammer to break 2 plastic wall plug into two holes. Tighten the screws with the plastic wall plug and locking with the shower holder. Then install the closed cover.

3. Connect the shower hose with the water outlet connection part and hand shower. Plug the hand shower in the shower holder.

A.

Valve Control Installation

a. Release 4 handwheel levers according to the above directions.

b. Take apart the embed valve, panel, and handwheel.

1. Dig the embed space for the pipe on the wall according to the specification of the valve.

2. Dig 4 holes according to the position of the screws.

3. Use a hammer to thwack the screws into 4 holes.

4. Fix the valve body with 4 screws.

5. Find out the expansion screw heads with washer and spring washer. Use copper sleeve wrench to lock the screw heads with the embed valve body.

6. After connecting all the pipes and before sealing the wall with concrete, confirm no leaking problem occur when you turn on the water.

7. Fix the decorative panel on the embed valve body.

8. Screw the handwheel arms with the handwheels.